Will be replaced with an updated system...stay tuned!

Introducing our TGS Custom Built Light & Sound FX Kit!  Turn your TGS Gen2 or Saber Kit into a light and sound masterpiece!  This kit comes pre-assembled as shown in the first two photos.  This is a direct plug and play component to the Gen1.9 Saber Kit, since the Saber Kit already includes a blade holder.  If you plan to build it into a TGS Gen2, just be sure you purchase the Deluxe Blade Adapter with it.  The sturdy custom 3D printed chassis mates well with our Deluxe Blade Adapter and many other Graflex blade adapters on the market (see aftermarket blade adapter note below).  With simple tools, you'll be up and rolling in no time!

With the included Nano Biscotte light and sound module, you can switch between many colors and sounds.  Any compatible sound fonts can be loaded onto the included SD card.  Be sure to follow the the Nano Biscotte V4 Manual and recommendations.  Up to 3 sound fonts can be included at a time.  Switch easily between each profile by holding down the red button switch until you hear the boot sound.

The Graflex Shop Nano RGB Kit includes the following premium components accurately assembled by the experts at TCSS:

    NB sound module base unit

    1ohm 2w resistor

    .3ohm 1w resistor

    .2ohm 1w resistor

    NB V4 AIO MWS Header and Wiring Harness

    2W 28mm Bass Speaker

    18650 Single Cell Holder

    SPST Momentary tactile switch

    Nano Biscotte V4 Sound Module + SD card

    Star thermal tape pad - Tri LED

    Red/Green/Royal Blue Cree XP-E2 CopperNova

    JST connector kit male and female

    Heatsink module for 1" ID tubes

    18deg Tri-Rebel/Cree Star Lens

    JST Male connector 26AWG Yellow short

    4-40 x 5/16" Button Head

    3D printed Chassis parts

OUT OF STOCK / PRE-ORDER - July ETA - The 'Pandemic Chip Shortage' got us too.

Requires a battery and blade for full effect, and are sold at The Custom Saber Shop.  Battery charger can be found here.  Battery, blade and charger are not included.

Do you have a non-TGS blade adapter?  If you do, measure your blade holder from the center of the front mounting hole to the end of your adapter.  This kit will fit adapters that have a measurement of 1 7/8 inch or less.

Write a review

Please login or register to review

Graflex Light & Sound FX Kit

  • $200.00